The Life Pro Bo PR70 comes with a range of advanced features and settings that can be customized to meet individual needs. The user manual provides detailed instructions on how to access and use these features, including:
: Verify that the minimum vertical clearance between the highest point of door travel and the ceiling is at least 40 mm .
Radio receiver, remote controls, emergency release cord.
Install safety photocells and a warning light for enhanced operation.
Ensure there is sufficient clearance for maintenance and manual release operations. The Life Pro Bo PR70 comes with a
Briefly tap the dedicated programming button. Press the desired button on your rolling-code remote control transmitter. Complete the registration process by tapping the Blue button one final time. Electronic Force & Obstacle Sensitivity
Briefly press the Blue button, then the transmitter button, and press the Blue button again to register. Adjustment Options:
: The installation area must have adequate space for manual release and maintenance. For sectional doors, a minimum vertical distance of 40mm from the ceiling is required.
Page 10 — Troubleshooting, Error Codes & Warranty Install safety photocells and a warning light for
Before commencing installation, operation, or maintenance of the Life PROBO PR70, read and understand all safety instructions contained in this manual.
Mounting distances depend entirely on whether you are working with a modern or a single-piece up-and-over tilt door .
Perform the auto-learning procedure to detect the limits of travel, obstacle detection, and deceleration points. 4. Use and Operation The PR70 operator offers several operational modes: Automatic: The door closes automatically after a set time.
Ensure the manual release handle remains pulled to allow free movement. Press the desired button on your rolling-code remote
Secure the door bracket to the top panel of the garage door. Connect the curved door arm to the door bracket. Connect the straight door arm to the rail trolley.
Before proceeding with installation, perform the following checks:
: Hold the red button for five seconds to adjust sensitivity; more LEDs indicate higher sensitivity for quicker inversion.
