Craftsman Digital Multimeter 82082 User Manual

Check the 9V battery connection or replace the battery.

Measuring current requires placing the meter directly "in series" with the circuit so the electricity flows through the multimeter.

Avoid physical contact with electrical ground pathways like metal pipes, conduits, or fixtures while measuring. 2. Layout, Controls, and Functions

Unscrew the screws on the back of the case and carefully separate the housing.

: Features an audible buzzer for continuity checks and a specific mode for testing diodes. Capacitance : Capable of measuring capacitance in circuits. Hardware & Interface Features Manual Ranging Selector craftsman digital multimeter 82082 user manual

: Provides clear, accurate readouts, though the screen is more compact than some professional models. Rugged Construction

Set the rotary switch to the desired V (DC) or V~ (AC) range. Touch the test probes to the circuit under test. Read the voltage on the display. Resistance Measurement Turn off all power to the circuit. Set the rotary switch to the Ohm position. Touch the probes to the component being tested. Read the resistance value. Continuity Test

: The red (positive) test lead plugs here for the vast majority of tests, including voltage, resistance, continuity, and low-current mA measurements.

This write-up is for informational use. Always refer to the physical manual included with your device for complete safety warnings and warranty terms. Check the 9V battery connection or replace the battery

Reassemble the case, tighten the screws, and slip the rubber holster back on. Troubleshooting Common Issues

Note: Current must be measured in series, meaning the meter must become part of the broken circuit path. Plug the into COM .

The Sears Parts Direct manual emphasizes that improper use can lead to injury or device damage.

Regular maintenance is essential to ensure the multimeter's accuracy and longevity: Capacitance : Capable of measuring capacitance in circuits

: Keep your fingers behind the finger guards on the test probes at all times during a measurement. Device Overview and Layout

Positive probe input for voltage, resistance, and diode checks. Hold Button: Freezes the current reading on the screen. 2. Safety Precautions (Must Read)

Ensure test leads are in good condition without exposed wires.

For currents under 200mA, plug the red lead into . For currents between 200mA and 10A, plug the red lead into the 10A jack. Set the dial to the corresponding A ⎓ range.