Omron M4 Hem 722c1 E Manual Jun 2026

If you have the HEM-722C1-E, it may store a limited number of results. Check the screen to see the average of the last three readings (if available). 5. Troubleshooting and Error Codes

The cuff was not inflated sufficiently or you moved during measurement.

Ensure your bladder is empty; a full bladder can artificially raise blood pressure. Correct Sitting Posture

With the unit turned on or off, press the Memory (O) button to view your most recent measurement. Omron m4 hem 722c1 e manual

Blood pressure fluctuates constantly based on stress, posture, and physiological factors. To get a true baseline reading, observe the following rules:

Apply the cuff to your left upper arm (or right if necessary), with the tube positioned in the center of your inner arm, aligned with your middle finger.

If the device encounters an issue during a reading, an error code will appear on the screen. Use this quick reference guide to resolve the problem: Error Code / Symptom Potential Cause Batteries are dead or inserted incorrectly. If you have the HEM-722C1-E, it may store

Proper cuff placement is the most critical factor in achieving an accurate reading.

Remember that your blood pressure monitor is a medical device that requires proper handling and storage. Keep records of your readings to share with your physician, who can help interpret trends and adjust treatment plans as needed. And always consult a healthcare professional for any medical concerns—your monitor is a tool for tracking, not a substitute for professional medical advice.

Remove tight-fitting clothing from your left upper arm. Do not roll up sleeves if they constrict your blood flow. Troubleshooting and Error Codes The cuff was not

Press the START / STOP button to power down. The monitor will automatically turn off on its own after a few minutes of inactivity to save battery life. 💾 Utilizing the Memory Function

: Avoid eating, smoking, bathing, or exercising for at least 30 minutes before measuring. Sit quietly and rest for 2. Applying the Arm Cuff

Put your arm through the cuff loop. The bottom edge of the cuff should be positioned .

Located on the rear side for optional mains power connection. 2. Setting Up Your Device