Narishige Pc10 Manual New (2025)

Center the glass capillary so the heater coil is positioned exactly at the midpoint of the tube.

In this configuration, the puller applies a single continuous heating phase. The weight blocks pull the glass capillary downwards in one smooth motion.

The PC-10 is a vertical puller that utilizes gravity to shape glass capillaries. Its design focuses on stability and reproducibility:

: Pulls the glass capillary at one stretch, typically used for creating supple pipettes. narishige pc10 manual new

(or equivalent 1.0mm O.D.) glass capillary through the heater coil.

Ensure the power outlet is properly grounded and matches the voltage specified on the device’s rear serial plate (typically 100V, 120V, or 220-240V).

Reduce the Heater 2 temperature or decrease the pulling weights. Troubleshooting Common Issues Probable Cause Corrective Action Glass does not part Heat settings are too low. Center the glass capillary so the heater coil

The first heating cycle softens the glass for a primary elongation (tapering).

More weight = sharper tips; Fewer weights = parallel, longer shanks. Sets the distance for the first and second pulls.

This is the essential heating element for the PC-10 (and the PC-100). Its technical specifications are as follows: The PC-10 is a vertical puller that utilizes

Lift the lower slider assembly until the glass enters the lower clamp, then tighten the lower clamping knob. Step 3: Setting the Pulling Weights

Remove the old coil and slide the leads of the replacement coil into the terminal blocks.