The modern driver automatically installed by Windows 10 often fails with a "Phased out" error. You must manually install an older version, such as the Prolific PL2303 Vista (v3.2.0.0) driver, to make the hardware recognizable. Installation Guide for Windows 10 davemaster/PIC-USB-Programmer-K150 - GitHub
Click . The yellow triangle warning should immediately disappear. Step 3: Configure Micropro Software
The chip is inserted backward, or it is not sitting tightly in the ZIF socket.
: Many K150 units use the Prolific PL2303 chip. Windows 10 often installs a modern driver that flags these older (and sometimes pirated) chips as "phased out" (Code 10 error). k150 pic programmer software windows 10
Rule of thumb: Pin 1 of the microcontroller usually aligns toward the lever side of the ZIF socket, but smaller chips (8-pin, 14-pin, 18-pin) must leave specific gaps at the top or bottom of the socket. 2. Select the Chip Model
Without correct drivers, none of the K150’s software (e.g., PICPGM , IC-PROG , or WinPIC800 ) will communicate with the programmer.
To make the K150 work, you must downgrade the Prolific driver to an older version (typically version 3.3.2.102 or 3.2.0.0) that still allows the clone chips to function. The modern driver automatically installed by Windows 10
often requires specific driver workarounds due to compatibility issues with its internal USB-to-serial chip. Key Software: Microbrn.exe
This is the dedicated burning software used to load .hex files onto the PIC chip. Step 2: Download and Install the Correct PL2303 Driver
If you encounter issues with the K150 PIC programmer software on Windows 10, here are some common troubleshooting steps: The yellow triangle warning should immediately disappear
Here is the step-by-step preparation guide to get your K150 running.
: Users must select the correct programmer version (typically File > Programmer to ensure compatibility. Phipps Electronics The Windows 10 Driver Challenge The K150 typically uses the Prolific PL2303HX
It does support 3.3V-only PICs (e.g., PIC24, dsPIC) or PIC32 without external level shifters.
This is the cleanest method for .
The K150 uses a generic USB-to-serial bridge chip (often the or a clone). Windows 10, especially versions 1607 and later, dropped support for older PL2303 drivers (pre-2012) due to stability and security issues. Consequently, Windows 10 may either not recognize the K150 or mark it with a "Code 10" or "Code 31" error in Device Manager.