is a Chinese manufacturer of USB controller chips. These are the tiny brains on the circuit board that act as the bridge between the NAND flash memory (where your files live) and the USB connector.
A: This can happen for several reasons. Your drive may have bad NAND blocks that the tool is struggling to map out. Try a different "Scan Level" setting like "Standard Scan" or "High Scan". If it consistently fails at the same spot, the physical NAND flash might be worn out or damaged, indicating a hardware failure.
Set to "Clear" or "Scan" based on the severity of the corruption.
Download and run or Flash Drive Information Extractor (Innostor) . Locate your USB drive in the device list. Look for the Controller Vendor and Controller Part Number .
Allows setting a specific capacity for the drive. firstchip mptools chipyc2019
Some MPTools require driver.
The code is an alternative identifier commonly returned by hardware scanners for the FirstChip FC1179 controller series. FirstChip controllers are prominently used by budget and ultra-low-cost USB manufacturers (such as Netac, Mirex, and various unbranded promotional flash drives) due to their inexpensive architecture.
A: Yes. MPTOOLS is a powerful tool that works directly on the drive's firmware. An incorrect setting, such as choosing the wrong flash ID, can render the drive completely unusable. This is why precise identification and careful step-following are critical.
: Click Start to begin the low-level format. Note that this will permanently erase all data on the drive. Common Issues FirstChip FC1178/FC1179 MpTools V1.0.5.2 (2022-06-01) is a Chinese manufacturer of USB controller chips
Another user encountered a common scenario: the USB drive showed a drive letter in Windows, but any attempt to access it resulted in the error "Please insert a disk into removable drive".
is a mass production software utility primarily used to repair, reformat, or re-initialize USB flash drives using FirstChip FC1178 or FC1179 controllers . It is frequently used to fix "No Media" errors, restore true capacity to "fake" high-capacity drives, and handle corrupted firmware that prevents the drive from being recognized by Windows. Technical Overview
: Allows modification of VID (Vendor ID), PID (Product ID), and serial numbers. Key Usage Steps Using this tool will erase all data on the flash drive.
In early 2019, the USB forensic community was rocked by a discovery: The widely used version of ChipGenius (a tool used to identify controller types so you can download the right MPTool) contained a . Your drive may have bad NAND blocks that
If ChipGenius identifies a FirstChip controller but MPTools shows an empty slot, your drive's firmware may be completely crashed. You must force the controller into . Open the plastic casing of the USB drive and use a needle or tweezers to short-circuit the data pins (usually pins 29 and 30) on the NAND flash chip while plugging it into the computer. Remove the short once the PC detects a new device. "Bad Flash" or "Too Many Bad Blocks" Error
Click the button. The progress bar in the drive's designated slot will change colors and display current tasks like "Erasing," "Scanning," and "Writing Firmware."
: Used to fix "Write Protected," "Disk is Full," or "Please Insert Disk" errors by re-flashing the controller firmware.
(password is often blank or "123456") to adjust the scanning mode. Use "Low-Level Format" for severe corruption. 4. The Flashing Process button at the top or next to your detected drive. The tool will begin scanning and flashing the firmware. ⚠️ Be Patient : This process can take anywhere from 20 minutes to over an hour depending on the drive's capacity and health. until the progress bar turns (Pass). If it turns
Experiences