Press the button. The controller will automatically manage the engine pre-heat (if necessary) and bring it to operating speed.
Relay output (RL1) controls spindle on/off. The analog output (0-10V) controls RPM. Manual diagram shows:
To access the programming menu, press the key. Use the numerical keys to navigate to the specific parameter code, change the value, and press ENT to save. Vital Parameter Codes Parameter Code Description Default / Recommended Setting P01 Target Feeding Length (mm) User-defined based on product P02 Target Batch Quantity User-defined batch size P03 High-Speed Limit Matches maximum motor driver frequency P04 Low-Speed (Starting Speed) Prevents motor stalling at startup P05 Acceleration / Deceleration Rate Higher values equal sharper speed changes P06 Electronic Gear Ratio (Numerator) Tailored to mechanical gear setup P07 Electronic Gear Ratio (Denominator) Tailored to mechanical gear setup P08 Photoelectric Tracking Mode 0 = Time mode; 1 = Color mark tracking Calibrating the Electronic Gear Ratio
You’ll primarily use the navigation arrows (up, down, left, right), the center button for selections, and the button to exit menus. The Main View: xc2003 controller manual
According to the official technical reference manual, the Xc2003 controller has specific physical and electrical specifications crucial for proper installation and maintenance.
Search the PDF for keywords like “EMI,” “debounce,” “pin 10 function,” or “spindle relay delay.” The manual’s index is sparse, but the content is dense.
Xc2003 - Controller for the versatility range of compressors Press the button
This comprehensive manual guide covers everything from physical button navigation and sequence setups to pressure adjustments, firmware flashing, and fault code diagnostic routines. 1. Hardware Interface & Navigation
Installation and deep configuration typically require professional expertise or specialized tools:
is a heavy-duty micro-controller built to manage the versatility range of portable air compressors. Known for orchestrating (Pressure Adjusted through Cognitive Electronics), it enables a single compressor to operate across multiple pressure and flow settings. This comprehensive guide provides step-by-step instructions on navigating, configuring, updating, and troubleshooting your Hardware Interface and Controls The Atlas Copco XC2003 Controller Go to product viewer dialog for this item. The analog output (0-10V) controls RPM
A: You can adjust the pressure bands by pressing and holding the Enter button and navigating to the pressure menu.
: Maintaining the original setup and using authorized parts is vital; unauthorized modifications can lead to fire risks or void warranties. Reference Documents