This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. RClamp0503F - Mouser Electronics
The LAC503P amplifier, and by extension, its schematic diagram, have numerous applications:
Download a generic buck converter calculator to fine-tune your feedback resistors, or use an oscilloscope to verify the SW node waveform (should be a clean 1.5MHz square wave).
If running the LAC503P near maximum current, ensure the PCB has adequate copper area for heat dissipation.
| Pin | Probable Function | Notes | |------|-------------------|-------| | 1 | Vcc (+5V or +12V) | Power input, decoupled with 100nF cap to pin 8 | | 2 | Oscillator input | RC network to ground for frequency setting | | 3 | Feedback / Sense | Analog input (0–5V range) | | 4 | Reference out | Typically 2.5V or 5V precision | | 5 | Logic input A | TTL or CMOS level | | 6 | Logic input B | | | 7 | Enable/Shutdown | Active low or high depending on mask | | 8 | GND | Ground plane | | 9-12 | Output drivers | Open collector or push-pull | | 13 | Fault indicator | Diagnostic LED driver | | 14 | Soft-start cap | External capacitor to GND | | 15 | Current limit input | Voltage divider from shunt resistor | | 16 | Vcc (or second supply) | For output stage |
Since specific articles are limited, your best bet is to look for "Generic PWM Controller Application Notes" or check specialized electronics forums:
