Premier Installation Manual — Galaxy Aqua
Green/Yellow striped wire (Ensure a sleeve covers any bare earth wires)
| Problem | Possible Cause | Solution | | :--- | :--- | :--- | | | No power supply. | Check isolator switch and main fuse. | | | Thermal cut-out activated. | Reset the thermal cut-out button (located behind the cover). | | Water not hot enough | Temperature dial set too low. | Increase temperature setting. | | | Incoming water very cold. | Increase flow rate or temperature setting. | | Water too hot / Steam | Water flow rate too low. | Increase water flow at the tap. | | | Blockage in inlet filter. | Isolate water, remove and clean filter. | | Leakage | Loose connections. | Tighten fittings and check washers. |
Requires a dedicated 230/240V AC supply with its own fuse and a double-pole isolation switch. galaxy aqua premier installation manual
Remove the front cover of the Galaxy Aqua Premier by unscrewing the retaining screws at the bottom.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Green/Yellow striped wire (Ensure a sleeve covers any
⚠️
: A common failure point is the TCO, which may trip if the unit overheats. The manual includes a white reset button on the top of the internal heating unit, but power be isolated before attempting a reset. Flow Switch Activation | Reset the thermal cut-out button (located behind
If you need further assistance, spare parts, or wish to contact a professional for repair, the following resources may be helpful.
Inspect all internal and external joints while the water is running.
If your water pressure drops, turn off the water and electricity, remove the front cover, unscrew the inlet elbow connector, and clean the mesh filter located inside the inlet assembly. Troubleshooting Guide Potential Cause Action Required Water remains cold on all settings